Within 10 seconds, start keying in your new personal code ( min.
The “ CODE” green LED lights up with a fixed light for about 10 seconds.
With the door open and the bolts outside, press the “ ON” key and, after that, the “ PROGRAMMING” key place on the inside side of the door (see Picture 1).
After this time, renewed readiness for operation will be indicated by the green “ OK” LED lighting up and a beep. After three attempts with incorrect codes, the keyboard will be disabled for one minute and this time will be indicated by the red “ ERROR”LED flashing. If the combination is incorrect, the red “ ERROR”LED will light up and the buzzer will sound.
Within this time, with the green LED “ ON”, turn the knob clockwise to retract the bolts.
The green “ OK” LED lights up for about five seconds.
Press “ ON”, key in the service code “111111”and press “ ENTER”.
Test for opening using the service code ‘111111’ (with door open and bolts extended):.
To screw the black screw after removing it compromises the safe operation. Remove completely ( without screwing it any longer) the blocking black screw, blocking the magnet, which is marked by a proper yellow tag. Use only and exclusively alcaline batteries. Unscrew the cover screw and put the batteries, of the type stated on the label, into the proper case on the rear of the lock (see picture 1)- Screw again the cover screw.
Before installing the safe, check that it works properly and read the instructions carefully to understand the operation.Įvery time a key is pressed the green “ OK” LED lights up and the buzzer sounds pressing the “ ENTER” key causes the green “ OK” LED to light up for correct procedures, or the red “ ERROR” LED to light up in the case of incorrect settings.
THE SAFE OFFERS TWO CODE TO BE SET UP, WE ADVISE TO USE BOTH OF THEM TO AVOID FORGETTING THEM.
ALL SAFES ARE PROVIDED WITH SERVICE CODE “111111”.
(the “ ENTER” and “ ON” keys are not valid in the combination).
DIGITS THAT CAN BE SET: minimum 6 – maximum 10.
TWO PERSONAL OPENING CODES WHICH CAN BE SET UP.
Internal programming key for a new personal code (in some models it is protected with a sliding cover).
“ ENTER” key to confirm code set and consent to the opening.
4 dedicated led and contacts for external emergency feeding in case of exhausted inner battery.
12 key membrane keyboard: 10 keys with 0 to 9 figures.
Try all of these procedures with the door open first, until you are familiar with how the safe works. Please read all of these instructions carefully before commencing using your safe. INSTRUCTION HANDBOOK FOR ELECTRONIC DOUBLE CODE SAFES